Shimadzu LC-10 - Method Setup - Acquisition - Analog Output

Shimadzu LC-10/20 System 4 Using the control module
4.2.4 Method Setup - Acquisition - Analog Output
Fig 27: Method Setup - Acquisition - Analog Output
Auxiliary Range
Sets output range of integrator terminals.
Caution: Auxiliary range will affect the acquired signal. For RID-10A and RID-20A
detectors use 0.25 mRIU/V to get correct signal values
Recorder Range
Sets the range of the recorder.
Synchronize with Auxiliary Range
Synchronizes the Recorder Range with the Auxiliary Range value.
Recorder Mode
Sets the output mode of the recorder terminals.
Ratio Range
Sets the range of the signal ratio calculation.
Ratio Threshold
Sets the threshold of the signal ration calculation.
- 40 -