Shimadzu LC-10 User Manual

Shimadzu LC-10/20 System 4 Using the control module
4.4.3 Method Setup - Acquisition
Fig 46: Method Setup - Acquisition - PDA Signal
Wavelength
Sets the wavelength of the desired analog signal. This value must lie in
the range set by the Start Wavelength and End Wavelength parameters
defined on the Method Setup - PDA tab.
Bandwidth
Sets how "wide" will the wavelength window be for the purpose of the
analog signal creation. This signal is created by calculation from several
wavelengths, not by hardware settings.
Polarity
Sets whether the increasing absorbance value will be counted as more
Positive or more Negative voltage signal.
Output Range
Defines the maximal output value of the analog signal.
- 62 -

Shimadzu LC-10 Specifications

General

Brand	Shimadzu
Model	LC-10
Category	Laboratory Equipment
Language	English