5 Configuration and Operating Principle of the ICPE-9000
5-24
5.18 ASC-6100F Autosampler (Option)
5.18.１Connection
(1) Connect the control signal cable connector provided with the autosampler to the autosampler and
the ICPE-9000's connector panel. (See "5.17 Connector Panel".)
(2) Connect the nebulizer's sample introduction tube (see "Fig. 5-8") and the autosampler's suction
tube to the connection tube (P/N 211-83687) provided with the ICPE-9000.
Cut the nebulizer's sample introduction tube and the autosampler's suction tube to appropriate
lengths before connecting them.
(3) Connect the autosampler's power cable to the extension cable.
(4) Turn ON the autosampler's power switch.
Refer to the instruction manual provided with the ASC-6100F autosampler for further details.
5.18.2 Consumable Items
The part detailed below is a consumable item required when using the ASC-6100F autosampler for the
ICPE-9000.
Refer to the instruction manual provided with the ASC-6100F autosampler for details on other
consumable items and maintenance parts specific to the ASC-6100F autosampler.
P/N Part Name
Approximate
Replacement
Period
Material
211-83697 CONNECTION
TUBE
1 month (*1) Made by Cole-Parmer (U.S.):
P-95609-30
(*1) Although the above connection tube is resistant to acids, alkalis, and many types of solvents,
check that it can be used beforehand.
To Next Page
Loading...
Need help?
General
