Shimadzu TOC-V CPH - Analysis Procedures; Instrument Connection and Standby

TOCV-CP_IMshort_Control-ver-2_Rev07F Page 20 of 22
(Software version ≥ 2.00) effective date: September 2007
III. Analysis
1 Connecting to the Instrument
- Open the Sample Table to be used and click the [Connect] button of the Tool bar
- Click “Use Settings on PC”
2 Start of analysis (standby - function)
- Click [Start] button of the Tool bar
- Define the Standby option
Parameters
Action/Description
System
Actual system name is displayed
Keep running
The instrument remains in the Ready state at the completion of the
analysis sequence even after analysis is completed
Shut down instrument
The instrument automatically turns off at the completion of the
analysis sequence
Sleep
The instrument enters the sleep state and restarts at a specified date
and time
Auto restart time
To set the restart time.
[Standby]
To verify the settings
Parameters
Action/Description
“Sparging/Acid
Addition” window
Shows again the vial settings parameter
[OK]
To verify the settings
Parameters
Action/Description
“Start ASI
Measurement” window
[Start]
To start the analysis