What to do if the LED lights up briefly but my Shimano Steps Camera Accessories doesn't power on?
If you press the satellite power button and the LED lights up briefly but the power doesn't turn on for your Shimano Steps Camera Accessories, the (main) battery level might be too low. Try charging the (main) battery. Also, check that the (main) battery is securely connected.
Why is the LED light off on my Shimano Steps Camera Accessories battery charger?
If the Shimano Steps Camera Accessories battery charger LED does not light up, check the charging plug. Ensure no foreign material is attached to the connection area. Remove and reconnect the charging plug. Also, the LED turns off when the battery is fully charged; this is normal. Remove and reconnect the power plug of the battery charger, and then charge again.
Why does my Shimano Steps Camera Accessories battery drain so fast?
If the Shimano Steps Camera Accessories battery depletes quickly, it could be that the battery has reached the end of its life. In this case, replace the battery with a new one. Alternatively, the battery's temperature might be outside of its operating range. Ensure you use the battery within its specified operating temperature range.
Why is the gear position not displayed on my Shimano Steps BT-E6010?
If the gear position is not displayed on your Shimano Steps Bicycle Accessories, it is only displayed when the electronic gear shifting unit is installed. Check if the electric wire connector is disconnected. If you are not sure, contact the place of purchase.
General| Battery Type | Lithium-ion |
|---|---|
| Nominal Voltage | 36 V |
| Nominal Capacity | 11.6 Ah |
| Watt-hour Rating | 418 Wh |
| Charging Time | 5 hours |
| Compatibility | Shimano Steps E6000 series |
| Weight | 2.55 kg |
| Operating Temperature | -10°C to 40°C |
| Compatible Charger | Shimano Steps EC-E6000 |
To Next Page
