Shimano Steps DU-E6001 - Using the Cable Band to Attach the Assist Switch to the Handlebar; Installing the Assist Switch

Installation
Using the cable band to attach the assist switch to the handlebar
14
 Using the cable band to attach the assist switch to the handlebar
1
Temporarily attach the cable band (A) to
the assist switch. Adjust the cable band
according to the length of the
handlebar.
(A)
(A) Cable band
The cable band is included in SW-E6000.
2
Attach the assist switch mounted with
the cable band to the handlebar.
 Installing the assist switch
1
Attach the assist switch to a ɸ 22.2
handlebar with the electric wire routed
under the switch and open the fixing
bolt cover (A).
(B)
(A)
(A) Fixing bolt cover
(B) Fixing bolt
2
Tighten the fixing bolt (B) with a
screwdriver (#2).
When removing the cycle computer, reverse
the procedure.
Tightening torque:
1.5 N·m
{14 in. lbs.}