25
Operation
Turning the power ON / OFF
•
The power cannot be turned on while charging.
•
If the bicycle has not moved for over 10 minutes, the power will automatically turn off (automatic power off function).
•
If using SC-E7000, the power supply is operated from the battery.
NOTE
Do not place your foot on the pedals when turning ON/OFF. This may cause a system error.
Turning the power ON and OFF via the cycle computer (SC-E6100)
•
If the built-in battery of the cycle computer isn't charged sufficiently, it will not power on.
•
The built-in battery of the cycle computer only charges when the cycle computer screen is on.
1.
Hold down the power button for 2 seconds.
Power button
Turning the power ON and OFF via the battery
It is possible to forcibly power off BT-E8010/BT-E8020 by holding down the power button for 6 seconds.
1.
Press the power button on the battery. The LED lamps will light up indicating remaining battery capacity.
NOTE
When turning on the power, check that the battery is firmly attached to the battery mount.
<BT-E6000/BT-E6001>
Power button
<BT-E8010/BT-E8014>
Power button
To Next Page
Loading...
