5
TO ENSURE SAFETY
TO ENSURE SAFETY
WARNING
• Be sure to follow the instructions provided in the manuals when installing the product.
Only use SHIMANO genuine parts. If a component or replacement part is incorrectly
assembled or adjusted, it can lead to component failure and cause the rider to lose
control and crash.
•
Wear approved eye protection while performing maintenance tasks such as
replacing components.
• For information on products not explained in this manual, refer to the manuals for each
product.
Be sure to also inform users of the following:
• Do not to pay excessive attention to the cycle computer display while riding. Otherwise,
you may fall off the bicycle.
• Ensure that head and tail lights can turn on before riding the bicycle.
• Do not disassemble the product. Disassembling may cause injury.
• Do not leave the cycle computer in an extremely high temperature surrounding
environment such as in a closed vehicle on a hot day, or near a heater. If a battery is
incorporated, that can result in an explosion of the built-in battery or the leakage of
flammable liquid or gas from it.
• Do not expose the cycle computer to excessively low pressures. If a battery is
incorporated, that can result in an explosion of the built-in battery or the leakage of
flammable liquid or gas from it. Transporting this product by air is not a problem.
For installation to the bicycle, and maintenance:
• Be sure to remove the battery and charging cable before wiring or attaching parts to the
bicycle. Failure to do so may cause an electric shock.
Disposal precautions
• Observe all federal, state and local environmental regulations when disposing of a cycle
computer that incorporates a battery. Disposal of this product into fire or a hot oven, or
mechanically crushing or cutting of it, can result in an explosion of the built-in battery.
To Next Page
Loading...
Need help?
General
