33
INSTALLATION/REMOVAL
Installing the brake hose
5. Insert the brake hose in the brake hose connection port.
The lever comes with a pre-installed olive. When inserting the hose, ensure it does not
snag on the olive.
Insert the hose up to the witness mark added beforehand on the surface of the hose is
covered.
Cover with a clean rag while conducting this procedure as some of the internal oil may
leak.
6. Tighten the connecting bolt.
5 - 7 N·m
Connecting bolt
7. Wipe off any residual oil and install the hose cover.
To Next Page
Loading...
