34
INSTALLATION/REMOVAL
Installing the brake hose
8. Remove the lever stopper from the brake lever.
Pull out the lever stopper by means of short back and forth movements while taking care
not to depress the brake lever.
Lever stopper
Brake lever
BL-M6100
Lever stopper
Brake lever
9. Check that the pad spacer is installed on the caliper and that the disc
brake rotor is between the two sides of the caliper.
10.
Operate the brake lever several times and check that the brake pads
grip the disc brake rotor and that the lever becomes stiff.
If the lever does not become stiff, refer to “Adding SHIMANO genuine mineral oil and
bleeding air” and bleed the air from the system.
To Next Page
Loading...
