Shimano EP600 - Important Safety Information; Battery Handling Dangers and Risks

Important safety information
Handling the battery
Do not deform, modify, disassemble, or apply solder directly to the battery.
Doing so may cause leakage, overheating, bursting, or ignition.
Do not leave the battery near sources of heat such as heaters, and do not heat the battery or throw it into a
fire.
Doing so may cause bursting or ignition.
Do not throw or subject the battery to strong shock.
Doing so may cause overheating, bursting, or ignition.
Do not place the battery into fresh water or sea water, and do not allow the battery terminals to get wet.
Doing so may cause overheating, bursting, or ignition.
When charging the specified battery, use the specified battery charger for charging and observe the specified
charging conditions.
Doing otherwise may cause overheating, bursting, or ignition.
If the battery does not become fully charged even 2 hours after the designated charging time, immediately
unplug the battery from the electrical outlet and contact the place of purchase.
Doing otherwise may cause overheating, bursting, or ignition.
Refer to the battery charger user's manual for the designated charging time of the battery.
Important safety information
4