14
Charging the battery
You cannot use the battery immediately after shipment. If the bicycle is stored for an extended period of time immediately
after purchase, you will need to charge the battery before using the bicycle. Once the battery is charged, it starts to
deteriorate.
The battery can be used after charging it with the designated charger.
Be sure to charge it before use. The battery can be used when the LED on it lights up.
The charging time will vary depending on the battery level and the battery charger being used. Refer to the battery charger
user's manual for the designated charging time.
The use of a genuine Shimano battery is recommended. If using a battery from another manufacturer, make sure to carefully
read the instruction manual for the battery before use.
Connect to E-TUBE PROJECT and click [Connection check] to confirm whether the battery in use is a genuine Shimano battery
or another brand.
DANGER
•
Use the Shimano specified charger and observe the specified charging conditions when charging the specified battery. Not doing so
may cause overheating, bursting, or ignition of the battery.
CAUTION
• When removing the battery charger power plug from the outlet or the charging
plug from the battery, do not pull it out by the cord.
• When charging the battery while it is mounted on the bicycle, be careful not to
trip over the charger cord or get anything caught on it. This may lead to injury or
cause the bicycle to fall over, damaging the components.
To Next Page
Loading...
