43
Connection and communication with devices
The system can be configured and firmware can be updated when the bicycle is connected to a device.
You need E-TUBE PROJECT to configure SHIMANO STEPS and update firmware.
Download E-TUBE PROJECT from the support website (http://e-tubeproject.shimano.com).
For information on how to install E-TUBE PROJECT, check the support website.
NOTE
• SM-PCE1/PCE02 is needed to connect SHIMANO STEPS E7000 Series to a PC. SM-JC40/JC41
will be needed in the following situations.
• There are no free E-TUBE ports on the cycle computer (for example, if using an
electronic gear shifter)
• Firmware is subject to change without notice. If necessary, contact the place of purchase.
• Connecting to devices is not possible while charging.
To Next Page
Loading...
