Basic Operation
c) Clean Objective Lens every week, or when it’s dirty.
NOTE: Do not touch or hit electrode tips (in this case electrodes do not remove
from the splicer).
➢ Select / Use the Suitable Splice Mode
How to select the “Splice Mode”
a) When splicing only standard SM fibers (ITU-T G.652), “SM AUTO”
mode is recommended.
b) When splicing many types of fibers, “AUTO” mode is recommended,
but splice speed is slow.
c) Splicing speed of “SM FAST” mode is fast, but periodical Arc
calibration is required.
➢ Clean the Equipment before Every Splicing
a) Clean the blade of stripper.
b) Clean the cleaver pads and blade and rubber anvil.
➢ Splicing Procedure
a) Make sure the stripped fiber is free of coating debris or contamination.
To Next Page
Loading...