Menu Operation
⚫ For those who prefer the lowest possible splice loss to any other
considerations. Use “AT1(SM)” and optimize splicing condition for your
specific fiber combination.
⚫ For those who prefer the manual splicing to type of optical fiber has
already been identified, use “SM”, “DS”, “MM1” or “NZ” depending on
the fiber type. Optimize splicing condition for your specific fiber
combination.
⚫ For those who splice non-conventional fibers, select the best suit splicing
mode in “BLANK”. “AUTO” splice modes do not cover
non-conventional fiber splicing.
➢ Database
For splcing in most cases, in which the
splicer will automacially adjust splice
parameters according to fiber type.
Automatic arc calibration works in this
splice mode.
For splicing standard Single-mode
fiber (ITU-T G652). The MFD is 9 to
10 um at wavelength of 1310 nm.
Automatic arc calibration works in this
splice mode.
To Next Page
Loading...