Basic Operation
⚫ When protection sleeve core tube is longer than the length of outer sheath,
the excess part should be cut off to avoid micro bend after heating.
B. Stripping and Cleaning Fiber
➢ Sheath Clamp
Strip fiber's outer coat 30 to 40 mm from its tip with a stripping tool. Clean
the fiber with alcohol (Purity ≥99%) impregnated gauze or lint-free tissue
thoroughly.
C. Fiber Cleaving
➢ Fiber holder System
a) Put container from the storage position to the work position; pull the
slider out of cleaver; open the large and small plate as shown below;
b) Set the fiber holder which is with a striped and cleaned fiber into the
To Next Page
Loading...