Menu Operation
1. Splice Mode Menu
A. Splice Mode
The optimum splice setting for a specific fiber combination consists of the below
listed splicing parameters. In other words, the optimum splicing parameters
depend on the fiber combinations, and are different from fiber to fiber.
⚫ Parameters for controlling arc discharge / heating.
⚫ Parameters for calculating estimated splice loss.
⚫ Parameters for controlling fiber alignment and splicing procedures.
⚫ Threshold for error messages.
A series of optimum splice parameters for major fiber combinations are already
stored in the splicer. These parameters are stored in the database area and can be
copied to the user-programmable area. These splice parameters can be edited for
a specific fiber combination.
➢ How to select the “Splice Mode”
⚫ For those who prefer stable splice loss (rather to quick splicing with high
yield). Use the “AUTO” mode.
⚫ For those who are not sure of the optical fiber type to be spliced. Use the
“AUTO” mode.
⚫ For those who would like to shorten splicing time with AUTO modes. If
the type of optical fiber has already been identified, use “AUTO SM”,
“AUTO DS”, “AUTO MM1” or “AUTO NZ” depending on the fiber
type. These exclusive AUTO modes skip a process for fiber type
identification, so the total splicing processes take less time.
⚫ For those who prefer quick splice of SMF with high yield to consistent
splice loss. Use “SM FAST” Mode
To Next Page
Loading...