Menu Operation
ambient temperature. The real Heat Time may vary from set Heat Time.
Sets heating temperature. Fiber coating may melt if Heat Temp is over 190℃
Sets Finish Temp (Finish Temperature). When heater approaches this
temperature the buzzer beeps announcing the sleeve is cooled down and is ready
to be taken out of the heater.
In “Select Heater Menu”, press button to enter “Heater Mode Edit” menu
as shown below:
Press or button to select the parameter to be modified, press
button to enter parameter setting.
Press or button to modify parameter, press button to confirm.
3. Splice Set
Splice Set include: Auto Start, Pause, Cleave Angle Display and etc.
To Next Page
Loading...