Basic Operation
a) Select the heater mode most suitable for the protection sleeve to be used.
Each tube-heating mode is optimized for a type of protection sleeve.
Other manufacture’s fiber protection sleeve may not shrink completely.
At that time extend the heating time.
b) Centering protection sleeve in tube heater
2. Power Supply
Use only supplied AC power cord.
Connect to ground with ground terminal of AC power cord.
➢ Battery
a) The capacity of the battery gradually decreases as nature even if it is not
used. If the battery discharges completely, the battery may no longer be
able to be re-charged. Charge the battery before long time storage and
after use.
b) If a battery is to be stored for a long time, periodical charge of every six
months is recommended regardless of battery charge level of the battery.
c) Follow below conditions for operation/charge/long time storage (1 week
or longer).
Operation: -10 ℃~ 50 ℃
Charge: 0 ℃ ~ 40 ℃
Long Time Storage: -20 ℃ ~ 30 ℃
Basic Operation
1. About Power
➢ Inserting Power Supply into Splicer
OFS-95 can be powered by external power adaptor and power supply unit.
a) Inserting or detaching power supply unit
Insert power unit into Power unit dock until it clicks into place.
b) Detaching power supply unit
To Next Page
Loading...