ShinewayTech OFS–95 - Page 34

Basic Operation
Prefuse power too low or
prefuse time too short.
Increase [Prefuse Power]
and/or [Prefuse Time].
MFD Mismatch
Arc power too low
Increase [Arc Power]
and/or [Arc Time].
Combustion
Bad fiber end-face quality
Check the cleaver
Dust still present after
cleaning fiber or cleaning
arc.
Clean fiber thoroughly or
Increase [Cleaning Arc
Time].
Bubbles
Bad fiber end-face quality
Check if fiber cleaver is
well conditioned.
Prefuse power too low or
prefuse time too short.
Increase [Prefuse Power]
and/or [Prefuse Time].
Separation
Fiber stuffing too small
Perform [Motor
Calibration]
Prefuse power too high or
prefuse time too long.
Decrease [Prefuse Power]
and/or [Prefuse Time].
Fat
Fiber stuffing too much
Decrease [Overlap] and
perform [Motor
Calibration].
Thin
Arc power not adequate
Perform [Arc Calibration]
Some arc parameters not
adequate
Adjust [Prefuse Power],
[Prefuse Time] or