ShinewayTech OFS–95 - Focus, Motor, and Angle Errors

Common Problems and Troubleshooting
• Splicing indistinct
core fibers with the
SM or DS modes.
• [Align] is set to
“Core” to splice
indistinct core fibers
when using other
splice modes.
• [Focus] is incorrectly
set when using other
splice modes.
• Set the [Cleaning Arc] time to
“30ms.” When splicing carbon
coated fibers, set to “100ms.”
• Use the MM mode to splice
indistinct core fibers (i.e. MM
fiber).
• Set [Align] to “Clad” to splice
indistinct core R-Too Dusty fibers
(i.e. MM fiber).
• Set [Focus] to “Edge” to splice
indistinct core fibers (i.e. MM
fiber). To splice distinct core fibers,
“Auto” or the correct focus value
should be entered.
Left/Right fiber
X/Y set error!
• The fiber is not set
correctly at the bottom
of the V-groove. The
fiber position is out of
focus range.
• Dust or dirt is on the
fiber surface resulting
in focus failure.
• Dust or dirt is on the
objective lens or the
wind protector mirror.
• Press RESET key, and re-position
the fiber again to seat it correctly at
the bottom of the V-groove.
• If fibers are not shown out fully,
please go to the 4th page of MENU
interface and choose "screen
adjust". Follow the description
shown on screen to let all edges of
fibers to show out.
• Completely prepare the fiber
again (strip, clean and cleave).
• Execute the [Dust Check]. Clean
the lens or mirror if dust or dirt
X/Y Motor out of
range!