Quick guide
1. Create a project group and set up project settings.
2. Set scan parameters on the preview page .
3. Scan and generate the point cloud.
4. Mesh.
5. Save the scaned data.
Quick calibration
Through calibration, the device parameters are recalculated, which not only ensures the
accuracy of the device, but also improve the scanning quality.
Note
Calibration is required under the following conditions:
When the scanner is used for the first time, or when it is reused after being laid idle for
a long period of time (1-2 weeks).
The scanner was severely shaken or vibrated, such as shaken during transportation.
Severe accuracy reduction, such as frequent errors in alignment or unrecognized
markers.
Incomplete data is acquired during the scanning or serious deterioration of the quality
of scanned data.
7 Edit Toolbar For more, see Data Edit.
8 Shortcuts Quickly move the model or adjust the angle
through shortcut keys.
9 Scan & Generate
Point Cloud
For more, see scanning。
10 Side Toolbar For more, see functions。
11 Other Information To show information about FPS, Frames in Total,
Points in Total, etc.
To Next Page
Loading...
