●Max triangles: Set max plate number to get
mesh model’s triangle plate number is within
configured plate number.
- Please enter this value reasonably to avoid
over-simplification resulting in poor data quality.
- Avoid entering extremely small numbers.
●Fill Small Hole：Automatically fill the small
holes with a smaller perimeter than the number
input.
●Remove Spike：Remove spike-like data on
the image edge.
●Marker Hole Filling：Fill in the holes on the
surface of objects that are not scanned due to
being covered by markers.
●Recommended Parameters：When turning
on, it will automatically use the recommended
parameters for meshing.
Click Apply to confirm the settings and start meshing.
Click Confirm to save it after meshing.
Click to restore.
Mesh Editing
After the model data is meshed, the software automatically switches to the post-processing
interface. Alternatively, users can directly click on the navigation bar to enter the post-
processing interface and import the data.
Left Panel
Click + to check the function.
To Next Page
Loading...
