9
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Control Modes
Stand-alone (Built-in Programs, Auto run, Static Colors, Sound control)
One Compact Par 7 MKII (Manual Control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Compact Par 7 MKII is not connected by a DMX-cable, it functions as a stand-alone
device.
05) Please see page 14 and 15 for more information about the manual control functions.
Multiple Compact Pars (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Use a 3-p XLR cable to connect the Compact Pars.
05) Link the units as shown in (Fig. 03), Connect a DMX signal cable from the first unit's DMX "out" socket
to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on page 14, 15 and 16 (Manual Control
or Music control). This means on the master device you can set your desired operation Mode and all
slave devices will react the same as the master device.
Multiple Compact Pars (Master/Slave control)
To Next Page
Loading...
Need help?
General
