Shure Incorporated
16/26
Issue Indicator Status Solution
Transmitter indicator LED
flashing red
Replace transmitter batteries (see Changing Bat
teries).
Audio artifacts or dropouts Ready LED flickering or off • Change receiver and transmitter to a different
group and/or channel.
• Identify nearby sources of RF interference, and
shutdown or remove source.
• Replace transmitter batteries.
• Ensure that receiver and transmitter are posi
tioned within system parameters
• System must be set up within recommended
range and receiver kept away from metallic sur
faces.
• Transmitter must be used in line of sight from
receiver for optimal sound
Distortion Audio LED on receiver indi
cates overload (red)
Reduce transmitter gain (see Adjusting Gain).
Sound level variations
when switching to different
sources
N/A Adjust transmitter gain as necessary (see Adjust
ing Gain).
Receiver/transmitter won't
turn off
LED/display flashing rapid
ly
See Locking and Unlocking Controls.
Specifications
System
Working Range
91 m (300 ft) Line of Sight
Note: Actual range depends on RF signal absorption, reflection and interference.
Audio Frequency Response
50 to 15,000 Hz
Note: Dependent on microphone type
Total Harmonic Distortion
Ref. ±33 kHz deviation with 1 kHz tone
0.5%, typical
To Next Page
Loading...
