L..ll~llo;JII
Important Product Information
Certifications
This product meets the Essential Requirements of all rel-
evant European directives and is eligible
forCE
marking.
The CE Declaration of Conformity can be obtained from
Shure Incorporated or any of its European representatives.
For contact information please visit www.shure.com
The CE Declaration of Conformity can be obtained from:
www .shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East
& Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49
11
4
Email: EMEAsupport@shure.de
BLX1,BLX2
Certified under FCC Part 7 4.
Certified by
IC
in
Canada under RSS-123 and RSS-1 02.
FCCID:DD4BLX1A,OD4BLX1B,DD4BLX1C,
DD4BLX1D;DD4BLX2A,DD4BLX2B,DD4BLX2C,
DD4BLX2D.
IC:
616A-BLX1
A,
616A-BLX1
8,
616A-BLX1C,616A-BLX1D;616A-BLX2A,616A-BLX2B,
616A-BLX2C,616A-BLX2D
BLX4,BLX88
Approved under the Declaration of Conformity (DoC) pro-
vision of FCC Part 15.
Band
Range
Output
Power
H8E 518 to 542 MHz
10mW
K3E 606 to 630 MHz
10mW
K14 614 to 638 MHz
10mW
M17 662 to 686 MHz
10mW
Q25 742 to 766 MHz
10mW
R12 796 to 806 MHz
10mW
sa
823 to 832 MHz
10mW
T11
863 to 865 MHz
10mW
NOTE:
This Radio equipment is intended for use
in
musi-
cal professional entertainment and similar applications.
This Radio apparatus may be capable of operating on
some frequencies not authorized in your region. Please
contact your national authority to obtain information on
authorized frequencies and RF power levels for wireless
microphone products.
Australia Warning
for
Wireless
This device operates under an
ACMA
class licence and
must comply with all the conditions of that licence includ-
ing operating frequencies. Before
31
December 2014,
this device will comply if it is operated in the 520-820 MHz
frequency band.
WARNING:
After
31
December 2014, in
order to comply, this device must not
be
operated in the
694-820 MHz band.
LICENSING INFORMATION
Licensing: A ministerial license to operate this equipment
may be required
in
certain areas. Consult your national
authority for possible requirements. Changes or modifica-
tions not expressly approved
by
Shure Incorporated could
void your authority to operate the equipment. Licensing
of Shure wireless microphone equipment is the user's
responsibility, and licensability depends on the user's clas-
sification and application, and on the selected frequency.
Shure strongly urges the user to contact the appropriate
telecommunications authority concerning proper licensing,
and before choosing and ordering frequencies.
Information
to
the user
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
in
a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed
and used
in
accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur
in
a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined
by
turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
the receiver.
• Connect the equipment to an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer
or
an experienced radio/TV
technician for help.
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation
of
this device is subject to the
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interfer-
ence, including interference that may cause undesired
operation of the device.
Le present appareil est conforme aux CNR d'lndustrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisee aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioelectrique subi, meme si le brouillage est susceptible
d'en compromettre le fonctionnement.
This Class 8 digital apparatus complies with Canadian
ICES-003. Cet appareil numerique de
Ia
classe B est con-
forme
a
Ia
norme NMB-003 du Canada.
Note:
EMC conformance testing is based on the use of
supplied and recommended cable types. The use of other
cable types may degrade EMC performance.
Changes
or
modifications
not
expressly
approved
by
the
manufacturer
could
void
the
user's
authority
to
operate
the
equipment.
Please follow your regional recycling scheme for batteries,
packaging, and electronic waste.
9
To Next Page
Loading...
Need help?
General
