EasyManuals Logo

Shure MV5 User Manual

Shure MV5
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
Shure Incorporated
14/15
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa
tion. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/NMB-3(B)
Note: Testing is based on the use of supplied and recommended cable types. The use of other than shielded (screened) cable types may degrade EMC per
formance.
This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Email: info@shure.de
Use of the Made for Apple badge means that an accessory has been designed to connect specifically to the Apple product(s)
identified in the badge and has been certified by the developer to meet Apple performance standards. Apple is not responsible
for the operation of this device or its compliance with safety and regulatory standards.
Apple, iPad, iPhone, iPod and Lightning are trademarks of Apple Inc., registered in the U.S. and other countries. tvOS is a
trademark of Apple Inc. The trademark “iPhone” is used in Japan with a license from Aiphone K.K.

Other manuals for Shure MV5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Shure MV5 and is the answer not in the manual?

Shure MV5 Specifications

General IconGeneral
Transducer TypeCondenser
Polar PatternCardioid
Frequency Response20 Hz to 20 kHz
Sensitivity-40 dBFS/Pa at 1 kHz
Maximum SPL130 dB SPL
ConnectivityUSB
Adjustable Gain Range0 to +36 dB
Connector TypeMicro-USB
Sampling Rate44.1 kHz/48 kHz
Power RequirementsPowered by USB
Headphone Output3.5 mm
CompatibilityiOS, Android, Mac, PC

Related product manuals