Shure MXCW - Installation Requirements Checklist

Shure Incorporated
26/93
•
•
•
◦
◦
◦
◦
◦
◦
•
•
•
Important: Always perform a "walk around" test to verify coverage before using a wireless system during a speech or
performance. Experiment with placement to find the optimum location.
Requirements Checklist
Make sure your equipment meets these requirements before installing the system:
Use shielded Cat 5e or higher Ethernet cables.
Use balanced XLR cables for analog input/output.
Use Gigabit DHCP router to connect multiple access points in the same installation. Ensure it meets the following
requirements:
Gigabit ports
Provides Class 0 PoE with at least 6.5 W
Quality of Service (QoS) with 4 queues
Diffserv (DSCP) QoS with strict priority
If the router features Energy Efficient Ethernet (or Green Ethernet), ensure it is disabled from the ports dedicated for
the system
Recommended: A managed switch to provide detailed information about the operation of each network link (port
speed, error counters, bandwidth used, etc.)
Limitingcablerunsto≤100metersbetweendevices.
Use same firmware version for all devices in your system.
Ensure MXCW components and the computer are on the same network and set to the same subnet.