Need help?Do you have a question about the Shure MXA902 and is the answer not in the manual?
General| Type | Ceiling Array Microphone |
|---|---|
| Microphone Type | Condenser |
| Element | Electret |
| Maximum SPL | 120 dB SPL |
| Color | White |
| Self-Noise | 28 dB SPL (A-weighted) |
| Connectivity | Dante, AES67 |
| Power Requirements | PoE (Power over Ethernet) |
| Control | Shure Designer |
Guides users through initial setup using Shure Designer software for the MXA902.
Explains how to configure audio routing and DSP settings for optimal performance.
Guides physical and network installation via the web application.
Details audio routing procedures using the web application and Dante Controller.
Describes how to test and fine-tune audio levels and coverage using the web application.
Explains how to use Designer to control MXA902 settings and coverage.
Guides on adjusting microphone input levels for clear audio capture.
Explains how to adjust loudspeaker output levels for optimal playback.
Provides general recommendations for installing the MXA902 for optimal performance.
Details the procedure for installing the MXA902 in a standard ceiling grid system.
Explains the function and importance of AEC for clear conference calls.
Details parameters for configuring Acoustic Echo Cancellation, including Reference Meter and ERLE.
Explains how to adjust audio frequencies for optimal sound quality.
Provides guidance on selecting appropriate network switches and cables for Dante.
Explains the IP address configuration for Shure control and Dante audio.
To Next Page
