Shure Incorporated
29/38
•
•
1.
2.
3.
4.
1.
Before turning encryption on or off, you must disable AES67 in Dante Controller.
AES67 cannot operate when the transmit and receive devices both support Dante.
Shure Device Supports: Device 2 Supports: AES67 Compatibility
Dante and AES67 Dante and AES67 No. Must use Dante.
Dante and AES67
AES67 without Dante. Any other au
dio networking protocol is acceptable.
Yes
Separate Dante and AES67 flows can operate simultaneously. The total number of flows is determined by the maximum flow
limit of the device.
Sending Audio from a Shure Device
All AES67 configuration is managed in Dante Controller software. For more information, refer to the Dante Controller user
guide.
Open the Shure transmitting device in Dante Controller.
Enable AES67.
Reboot the Shure device.
Create AES67 flows according to the instructions in the Dante Controller user guide.
Receiving Audio from a Device Using a Different Audio Network Protocol
Third-party devices: When the hardware supports SAP, flows are identified in the routing software that the device uses. Oth
erwise, to receive an AES67 flow, the AES67 session ID and IP address are required.
Shure devices: The transmitting device must support SAP. In Dante Controller, a transmit device (appears as an IP address)
can be routed like any other Dante device.
Paint Square Array Microphones
You can paint the grille and frame of square ceiling array microphones to blend in with a room's design.
Note: Don't remove any of the screws on the MXA902's loudspeaker enclosure while painting.
Step 1: Remove the Frame and Grille
On each side of the frame, remove the 6 screws and washers that attach the main assembly to the frame.
Important: Do not remove the 4 recessed screws in each corner.
To Next Page
Loading...
