3. After attaching the brackets, mount the unit in an equipment rack using the supplied rackmount screws and
plastic washers.
Stand-Alone Installation
1. Adhere the four (4) supplied rubber feet to the bottom of the unit at each corner. This will keep it from
sliding and protect the table surface.
Fixed Installation
To permanently affix the SCM262 above or below a table, shelf, or counter top, use the following steps:
1. Fasten the straddle brackets to the recessed edges of the chassis using four (4) bracket screws.
Top Mount: Fasten the straddle brackets to the bottom of the unit.
Hanging Mount: Fasten the straddle brackets to the top of the unit.
2. Fasten the straddle brackets to the surface using the four (4) supplied wood screws.
Publications
To Next Page
Loading...
