Word records made to the set parameters are automatically recorded
in a symbol report of each measurement and, then, they can be read in all
records (including when transferring data to a stationary computer, etc.).
In order to save time when carrying out the work directly on a well, it
is recommended to set necessary parameters beforehand.
Modes description
1. The measurement of the pressure and the battery voltage.
Indication of time and date. The device starts operating in this mode
immediately after switching on. Example:
1. Battery voltage – 95%,
2. Pressure - 10,6 kilogauss/cm
2
,
3. Current time - 12 h. 20 m. 26 sec
4. Current date – 24 September 2012 года.
2. Indication and setting up the number of well, cluster and field. In
order to change the number press «INPUT/OUTPUT» button — the six
bits of the well number start flashing. Using «MODE» button, choose
what to correct: the well number, the well cluster number or the field
number. Then press «INPUT/OUTPUT» button. The high-order digit
starts flashing. Correct the necessary value by the consecutively pressing
of «INPUT/OUTPUT» button. Pressing «MODE» button you can
choose next digit or digits of number of the well/cluster to correct. All
correction is stored into the tool memory automatically. There is a
possibility to put the letters from the Cyrillic alphabet as the last two
bits in the number of well and the well cluster. The maximum quantity
of places for the well number is 6 bits, for the well cluster number- 5
bits, for the field number-3 bits. Example:
To Next Page
Loading...