1 – GENERAL CHARACTERISTICS
Aqua Ionic manages SIATA multi-way valves for the creation of water treatment devices.
The regenerative cycle, which is completely programmable, can be activated in either of the
following ways:
after a programmable time during which the probe detects that the water is not good;
immediately when the treatable volume is exhausted;
manually, using the Manual Regen key;
immediately by means of the Remote Start external signal.
Aqua Ionic is provided with an eeprom memory where the programming is stored, and of a buffer
battery allowing to keep the working parameters in the memory in the event of a supply voltage
failure.
Aqua Ionic, as well as all the other SIATA controllers, is compliant with the EEC Directives and is
built in the SIATA factory in Montespertoli, Florence (Italy) working with the Quality System
certified according to the following standard
ISO 9001 / UNI EN ISO 9001.
2 – TECHNICAL DATA
Supply voltage 230 Vac 10% (*)
Mains frequency 50 Hz 3% (*)
Absorbed power 4.6 VA
Working temperature 4° C – 40° C
Case size 165 mm x 127 mm x 70 mm
Total weight from 1 to 1.7 Kg
(*) Special versions available upon request.
To Next Page
Loading...
