190 GC315xx and GC400xx Technical Manual
Related parameters: P.0700 Engine type
P.0704 Can-Bus anomalies disable mask
To disable: bit 11 of P.0704 on
Enabled in: MAN, AUTO, TEST, REMOTE START
This protection is enabled only if the board is connected to the engine via the CAN BUS
(P.0700 different from zero). It is activated when the engine signals the battery-charger
alternator failure status over the CAN BUS.
Type: Failure
Connected parameters: P.0379 P.0380
To disable: P.0380 = 0
Enabled in: MAN, AUTO, TEST, REMOTE START
It is enabled only if the engine has been started by the controller (if the command for the fuel
electro-valve is activated) and it is disabled in engine start-up and stop phases. It is activated
if the reactive power is positive and higher than threshold P.0379, consecutively for time
P.0380.
ATTENZIONE! La protezione non lavora quando i trasformatori di corrente sono
collegati sulle utenze e quando le utenze sono alimentate dalla rete o da altri gruppi
elettrogeni.
Type: Alarm
Category: Engine protection
Related parameters: P.0700 Engine type
P.0704 Can-Bus anomalies disable mask
To disable: bit 10 of P.0704 on
Enabled in: MAN, AUTO, TEST, REMOTE START
This protection is enabled only if the board is connected to the engine via the CAN BUS
(P.0700 different from zero). It is activated when the engine signals the overspeed state over
the CAN BUS.
Type: Warning
Category: Engine protection
Related parameters: P.0700 Engine type
P.0704 Can-Bus anomalies disable mask
To disable: bit 4 of P.0704 on
Enabled in: MAN, AUTO, TEST, REMOTE START
This protection is enabled only if the board is connected to the engine via the CAN BUS
(P.0700 different from zero). It is activated when the engine signals the coolant high
temperature state over the CAN BUS.
Type: Warning/Alarm
Category: Engine protection
Related parameters: P.0700 Engine type
P.0704 Can-Bus anomalies disable mask
To disable: bit 5 of P.704 on
To Next Page
