5 Mounting
5.1 Commissioning requirements
•
Computer with Internet access to download connection diagrams in the respective
ID sensor product documentation, accessible as a PDF on the ID sensor product
page on the web (visit www.sick.com and enter the relevant product name in the
search).
•
Supply voltage: see "Technical data", page 21 and type label of the ID sensor to
be connected
•
Only perform mounting, connection, and configuration work at ambient tempera‐
tures of 0 °C to +40 °C!
•
Use at ambient temperatures 0 °C to –35 °C only when at rest (no mounting,
connection, or configuration work).
5.2 Mounting the connection module
•
Can be mounted with the cover closed.
•
Unobstructed access to the internal AUX male connector is required at all times in
order to access the ID sensor via RS-232 (configuration and diagnostics)
•
Maximum length of cable between the connection module and ID sensor when
using the serial data interfaces: 10 m
•
Removable cover with connection diagram can be rotated 180° and locked in
parking position
1. Hole and housing dimensions, see "Dimensional drawing", page 22, max. screw
diameter: 4 mm.
2. For installation and commissioning of the optional CMC600, refer to the CMC600
operating instructions at www.sick.com.
5 MOUNTING
12
O P E R A T I N G I N S T R U C T I O N S | CDB620 8021690/ZZN1/2021-05-07 | SICK
Subject to change without notice
To Next Page
Loading...
Need help?
General
