2 Safety information
2.1 Intended use
The ICD890 device is an intelligent camera for identifying and decoding 1D codes and
2D codes on moving objects. The device can also execute a variety of image processing
algorithms. The processed image information and read results for the 1D codes and 2D
codes are transmitted via CAN or Ethernet to a higher-level SICK controller (e.g.,
MSC800 oder SIM2000) or directly to the customer system. The outstanding image
quality also makes the camera suitable for use in OCR and video coding applications.
The camera is always operated in a mechanical combination with a compatible, applica‐
tion-dependent variant of the ICI890 illumination. The camera is mounted on the rear
of the illumination unit and is electrically connected to it. The illumination unit is trig‐
gered by the camera during the read cycle.
The device is designed for use in industrial applications and meets the requirements
for industrial ruggedness, interfaces and data processing.
Further image processing related functionality can be developed and made available on
request.
SICK AG assumes no liability for losses or damage arising from the use of the product,
either directly or indirectly. This applies in particular to use of the product that does not
conform to its intended purpose and is not described in this documentation.
2.1.1 Operating restrictions
NOTICE
Radio interference may occur when the device is used in residential areas!
■
Only use the device in industrial environments (EN 61000-6-4).
2.1.2 Conditions for specified enclosure rating
To ensure compliance with the specified IP65 enclosure rating of the device during
operation, the following requirements must be met: If these requirements are not met,
the device does not fulfill any specified enclosure rating.
•
The camera is mounted flush onto the ICI890 illumination unit by means of 4
screws.
•
The storage media cover on the rear of the device is screwed tight to the device.
For the recommended tightening torque for the cover screws, see "Mechanics/
electronics", page 36.
•
The cables plugged into the electrical M12 connections on the sides of the device
are screwed tight.
•
Any electrical M12 connections that are not being used must be sealed with pro‐
tective caps, depending on type. These plugs or caps must be screwed tight (as
delivered).
NOTICE
Only operate the device without the storage media cover for a short period while insert‐
ing or removing the optional storage media (SSD drive, microSD memory card).
During this time, protect the device against moisture and dust.
SAFETY INFORMATION 2
8023775/18IM/2020-07-02 | SICK T E C H N I C A L I N F O R M A T I O N | Camera ICD890 Generation 4
7
Subject to change without notice
To Next Page
Loading...
