SICK Lector63 Flex C-mount Series User Manual

DANGER
Risk of injury due to hot device surface.
The surface of the device can become hot during operation.
•
Before performing work on the device (e.g. mounting, cleaning, disassembly),
switch off the device and allow it to cool down.
•
Ensure good dissipation of excess heat from the device to the surroundings.
WARNING
Electrical voltage!
Electrical voltage can cause severe injury or death.
■
Work on electrical systems must only be performed by qualified electricians.
■
The power supply must be disconnected when attaching and detaching electrical
connections.
■
The product must only be connected to a voltage supply as set out in the require‐
ments in the operating instructions.
■
National and regional regulations must be complied with.
■
Safety requirements relating to work on electrical systems must be complied with.
WARNING
Risk of injury and damage caused by potential equalization currents!
Improper grounding can lead to dangerous equipotential bonding currents, which may
in turn lead to dangerous voltages on metallic surfaces, such as the housing. Electrical
voltage can cause severe injury or death.
■
Work on electrical systems must only be performed by qualified electricians.
■
Follow the notes in the operating instructions.
■
Install the grounding for the product and the system in accordance with national
and regional regulations.
2.8 Warning sign on the device
Devices and illumination units with LEDs in risk group RG 2 are provided with the follow‐
ing warning label.
Figure 1: Risk Group 2: CAUTION - Possibly hazardous optical radiation emitted from this product.
Do not look into the lamp during operation. This could damage your eyes. ICE 62471:2006-07;
EN62471:2008-09
The warning label is located on the exterior of the housing of the devices. For the illumi‐
nation units, the warning label is located on the outer ring.
The mounted optics protective hood covers the warning label on the illumination unit.
The integrable illumination unit types in risk group RG 2 that are mounted by the user
are therefore accompanied by an additional black and yellow warning label for optical
radiation of risk group RG 2.
Attach the additional warning label in a well visible location on the outside of the optics
protective hood of the device.
2 SAFETY INFORMATION
12
O P E R A T I N G I N S T R U C T I O N S | Lector63x Flex C-mount and S-mount 8018071/16XD/2020-05-06 | SICK
Subject to change without notice

SICK Lector63 Flex C-mount Series Specifications

General

Brand	SICK
Model	Lector63 Flex C-mount Series
Category	Barcode Reader
Language	English