SICK PGT-10-Pro

6.6 Reading Parameter Sets from the SD Card
NOTE
To program the parameter sets, the PGT-10-Pro must always be connected to a suitable
encoder.
Preparation
CAUTION
Only use an adapter cable that is suitable for the encoder (see “Accessories”).
The programming tool must only be used with the designated adapter cables. Other
adapter cables are not permitted. Otherwise, this could result in damage to the pro‐
gramming tool and/or the encoder.
Programming Encoders
•
Insert the SD card (FAT32 formatted) with the prepared parameter values into the
PGT-10-Pro.
•
Connect the encoder to be programmed to the PGT-10-Pro.
•
Load the parameters for the encoder type to be programmed to the memory using
the Read Configurations from SD-Card function.
•
Confirm the programming of the connected encoder with the selected parameter
set by pressing the enter pushbutton.
•
The parameter values programmed in the encoder can be checked using the Read
Encoder Settings function.
•
Disconnect the encoder from the adapter cable.
The encoder is fully programmed and ready to use.
OPERATING INSTRUCTIONS
8018708/1GQ6/2023-01-17 | SICK O P E R A T I N G I N S T R U C T I O N S | PGT-10-Pro
37
Subject to change without notice
en