SICK SIG200 - Page 30

Function name Index Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
IOL_Call 46080
(0xB40
0)
0 IOL_CALL extended function number (0x08)
1 IOL_CALL port
2 IOL_CALL function invocation index (0xFE4A)
3
4 IOL_CALL control/status
5 IOL_CALL index
6
7 IOL_CALL subindex
8 IOL_CALL data
…
N
NOTE
The Indices 0xB100…0xB103 are only applied if Port Configuration Mode (PCM) is set
to “IO-Link tool based configuration”.
IO-Link Device Record Data (Slot 2, subslots 2…5)
Function name Index Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
IOL_CALL 46080
(0xB40
0)
0 IOL_CALL extended function number (0x08)
1 IOL_CALL port (irrelevant)
2 IOL_CALL function invocation index (0xFE4A)
3
4 IOL_CALL control/status
5 IOL_CALL index
6
7 IOL_CALL subindex
8 IOL_CALL data
…
N
IOLD Backup 47361
(0xB90
1)
0 Block major version number (“1”)
1 Block minor version number (“0”)
4 Data Storage object
NOTE
The submodules “Digital input” and “Digital output” for the IO-Link Device ports (Slot 2,
Subslots 2…5) don’t have any record data.
Record data parameters
The parameters for all record data are defined as follows:
Parameter
Definition
PCM (Port configuration mode) Function “Port configuration mode” (see "Port configuration
mode", page 32)
Validation and Backup Function “Inspection Level”
Expected Vendor ID Function “Expected Vendor ID” (see "Expected Vendor ID",
page 33)
7 SIG200 CONFIGURATION
30
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200 8017853/2019-06-06 | SICK
Subject to change without notice