Further settings like minimum cycle time or port label assignment can be done as well
on this page.
On the IO-Link Devices tab there is a page for each IO-Link port (S1-S4). This tab dis‐
plays the IODD view, device info and parameter data for each IO-Link device. The page
visualization when an IODD was already uploaded to the user interface is different to
the visualization of the IO-Link device without uploaded IODD file. For a more conve‐
nient use it is recommended to upload the relevant IODD file for the IO-Link devices.
Figure 14: Configuration page
7.3.4.1 Gateway
The Gateway tab allows configuring the Ethernet settings.
Figure 15: Configuration page, Gateway
7.3.4.2 PROFINET settings
This tab provides several possibilities to configure the structure and size of process
data to be exchanged between the PLC and the Logic Editor.
The expected input and output size matches the Logic Editor submodule 2 in slot 1
from the PROFINET configuration stored in the SIG200. In order to guarantee correct
process data transfer, the expected size should correspond to the selection.
The structure of the process data can be adjusted according to the application and
logic by changing the Input and Output Data Configuration. This is important in terms of
handling differnet data types in the logic editor.
SIG200 CONFIGURATION 7
8017853/2019-06-06 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
47
Subject to change without notice
To Next Page
Loading...
