If the selection of the right IODD is done, click on the "Apply" button to confirm this
activity. The information from the IODD will appear now on the IO-Link device tab.
NOTE
The upload of one IODD file takes a few minutes. Depending on the size of the specific
IODD file the upload is faster or slower. It is not unusual in case the IODD upload needs
1-5 minutes or longer untill the IODD is fully visualized in the user interface.
Figure 18: Configuration page, IO-Link ports
The port owner defines who is able to write process data output. This can be set to
either Fieldbus, REST or Logic editor. Be aware, in case you set this to “REST”, you will
not see available process data outputs on the logic editor page.
The Min Process cycle time is as fast as possible and can not be changed when Field‐
bus is the port owner because the port configuration is coming from the PLC.
Data storage can be configured according to the demanded use case "Restore" and
"Restore & Backup". When data storage shall be used, it is required to set "Expected
Device and Vendor ID".
NOTE
If you have configured an IO-Link port, please press “apply” to change the configura‐
tion. Without pressing apply, your configuration will not be sent to the device.
NOTE
In case the port owner is set to "Fieldbus" the configuration is set by the PLC and can‐
not changed through the UI.
7.3.4.4 IO-Link devices
IODD view
The SIG200 user interface is vendor indepedent and can be used to connect and visu‐
alize any IO-Link device with port class A from any manufacturer.
SIG200 CONFIGURATION 7
8017853/2019-06-06 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
49
Subject to change without notice
To Next Page
Loading...
