The IO-Link device tab shows the connected IO-Link device on each port. Please make
sure the right port (S1-S4) on top of the page are selected and that the correct IODD
has been uploaded and assigned to the port.
The page is structured into three parts: Identification (left side), Process data (middle)
and service data (right side).
So this page allows the parametrization of the IO-Link device in an easy way in case a
corresponding IODD file was uploaded before.
NOTE
This page needs some time for loading all IO-Link device data. There is no "loading"
information appearing. It can happen that the visualization needs ~20 s or more untill
all parameters are visualized.
The following figure shows the view in case a corresponding IODD file for an IO-Link
device was uploaded:
Figure 19: Configuration page, IO-Link devices
NOTE
The correct IODD file must be uploaded and provided in the device configuration for this
section to be displayed.
The following figure shows the view if no IODD file is supplied; default IO-Link parame‐
ters are visualized:
7
SIG200 CONFIGURATION
50
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200 8017853/2019-06-06 | SICK
Subject to change without notice
To Next Page
Loading...
