SICK WI130 - Setting Display Values to Zero; Teach In All Devices; Configuring Standard Values for Length Measurement; End Detailed Configuration (Expert Mode)

Table 18: Setting the display values to zero.
TOP
A L 0 n o
Display values of all bus-connected WI130 devices are set to
zero.
select and adjust . The display reverts to the Zero
value top menu.
n o
Does not perform the zero‐
ing.
y E s
Performs the zeroing.
NOTE
The locked evaluation unit will not be reset.
↓
5.10 Teach in all devices.
Table 19: Teach in all devices
TOP
A L t n o
All bus-connected WI130 devices are taught in.
select and adjust . The display reverts to the
Single Value Teach-in top menu.
n o
Does not perform a teach-
in.
y E s
Performs all Single Value
Teach-in
NOTE
The locked evaluation unit will not be reset.
↓
5.11 Configuring the standard values for length measurement function
Table 20: Configuring the standard values for length measurement function
TOP
L r E F o F F
Select the width of the sensor head to be detected.
select and adjust . The display reverts to the
Length measurement top menu.
o F F
Function deactivated
3 0 0 0
Set to 3000
NOTE
Applies only to WSE130L-52/54.
5.12 End detailed configuration (expert mode)
Elt
7.Completing the configuration
Reverts to the Detailed settings top menu.
OPERATING INSTRUCTIONS
56
O P E R A T I N G I N S T R U C T I O N S | Evaluation unit WI130 8020148.1HRJ/2023-02-08 | SICK
Subject to change without notice
en