Siebeck JET 2000 - Correct Product Positioning for Strapping

Siebeck GmbH Translation of the original operating manual jet_in_bed_0315
Seite 11
Correct positioning of the products to be strapped
1. The products to be wrapped (ring) should be run in each case for
the first and any other binding up across the contact surface
marked on the table top (see figure below).
2. After the first binding, the product is run further to the right and
again to just over the contact surface.
If two strappings are not enough, the process must be repeated.
3. If the product is pushed beyond the contact surface, the wrapping
becomes loose. If the product is run just in front of the contact
surface, then there is a fault in the binding, or the string tears.
Kordel
Kordel
Anlegekante
A
nleg
ekante
Nadelschuh Nadelschuh
Tischplatte
Tischplatte
A
nlegekante
Anlegekante
Ring
Ring
1 2