Siebeck GmbH Translation of the original operating manual jet_in_bed_0315
Seite 12
Service and maintenance of the machine
To prevent accidents when cleaning and servicing the machine, it
is essential to make sure that the main switch is turned off, or the
machine power supply is switched off. The manufacturer of the
machine is released from any liability if this mandatory
requirement is not observed.
Cleaning the machine
After a running time of approximately 40 hours, the machine must be
cleaned thoroughly. The table top must be removed so that the
knotting aggregate is exposed and can be easily cleaned. Clean with
a vacuum cleaner and do not use compressed air.
Lubrication schedule
After a running time of approximately 40 hours, all lubrication nipples
must be lubricated (use only oil, no grease). All lubrication points
marked in red must be lubricated with an oil can twice a week. All
moving parts must be oiled once a week.
To Next Page
Loading...