Siemens 3WX3641- JD00 Series User Manual (English)

Questions and Answers:

J
Jennifer FarleyAug 15, 2025
What to do if Siemens Industrial Equipment breaker won't close electrically?
- L
  Laura WatsonAug 15, 2025
  If your Siemens Industrial Equipment breaker will not close electrically, but the ready-to-close indicator is OK, consider the following: * The operating voltage of the stored-energy activation solenoid might be incorrect or unavailable: Check or apply the correct voltage. * The circuit-breaker may be in the disconnected position in the guide frame: Crank the circuit-breaker into the test or connected position. * The auxiliary circuit plug may be taken out: Plug in the auxiliary circuit plug.
M
mcollinsAug 20, 2025
Why can't I fit the crank for racking my Siemens Industrial Equipment?
- M
  milleranthonyAug 20, 2025
  If you cannot fit the crank for racking on your Siemens Industrial Equipment, check the following: 1. Ensure the OFF push button is pressed: Press the OFF pushbutton and move the slide simultaneously to the right. 2. Verify the switchgear cabinet door is completely closed: Close the switchgear cabinet door. 3. Check for obstructions in the crank hole: Remove any padlocks that may be closing the crank hole.
D
dwilsonAug 26, 2025
What to do if Siemens Industrial Equipment breaker is stuck in maintenance position?
- Z
  zcampbellAug 26, 2025
  If the Siemens Industrial Equipment breaker cannot be moved from the maintenance position to the disconnected position, consider these causes: 1. The racing-in mechanism of the breaker is not in the disconnected position: Crank the mechanism into the disconnected position. 2. An attempt was made to fit a breaker with a different rated current in the guide frame: Only insert a circuit-breaker with the same rated current data as the guide frames. 3. The coding of the breaker and guide frame do not match: Only insert circuit-breaker with the same rated current data as the guide frames.
E
Emily WallsAug 30, 2025
Why can't I pull out the guide rails on my Siemens Industrial Equipment?
- M
  Megan ArnoldAug 30, 2025
  If the guide rails of your Siemens Industrial Equipment cannot be pulled out for fitting a circuit-breaker, it might be because the shutter is locked with one or two padlocks. Remove the padlocks to resolve this issue.
F
frichardsonSep 4, 2025
What causes resistance when cranking Siemens Industrial Equipment from disconnected to test?
- M
  Mr. Robert Nelson PhDSep 4, 2025
  If you feel strong resistance immediately after leaving the disconnected position when cranking your Siemens Industrial Equipment from the disconnected into the test position, it may be because the breaker is not pushed right in, and the lateral latches are not yet engaged. Push the breaker as far as the stop into the disconnected position until the latches at the side engage.