Siemens 4 F-DI/3 F-DO DC24V PROFIsafe - 2.2 Assigning Modules

Configuring
2.2 Assigning Modules of an ET 200S
ET 200S Distributed I/O System - Fail-Safe Modules
22 Installation and Operating Manual, 08/2008, A5E00103686-07
2.2 Assigning Modules of an ET 200S
Introduction
This section presents the ET 200S module assignments for:
● Fail-safe power modules to terminal modules
● Fail-safe electronic modules to terminal modules
● Power modules to electronic modules/motor starters
Assigning Fail-Safe Power Modules to Terminal Modules
You can use the F-power modules with the following terminal modules:
Table 2- 1 Assigning Fail-Safe Power Modules to Terminal Modules
F-Power Modules Terminal Modules For a Description, See ...
TM-P30S44-A0 (screw-in type) PM-E F pm DC24V PROFIsafe
and
PM-E F pp DC24V PROFIsafe
TM-P30C44-A0 (snap-in type)
PM-D F DC24V PROFIsafe TM-PF30S47-F1 (snap-in type)
Terminal Modules manual
for the ET 200S
distributed I/O system
Assigning Fail-Safe Electronic Modules to Terminal Modules
You can use the following fail-safe electronic modules and terminal modules together:
Table 2- 2 Assigning Fail-Safe Electronic Modules to Terminal Modules
F-Electronic Modules Terminal Modules For a Description, See ...
TM-E30S46-A1 (screw-in type)
TM-E30C46-A1 (snap-in type)
TM-E30S44-01 (screw-in type)
4/8 F-DI DC24V PROFIsafe,
4 F-DI/3 F-DO DC24V
PROFIsafe, 4 F-DODC24V/2A
PROFIsafe and
1 F-RO DC24V/AC24..230V/5A
TM-E30C44-01 (snap-in type)
ET 200S Distributed
I/O System
Operating
Instructions