5-3
Primer: S7-300 Programmable Controller, Quick Start
C79000-G7076-C500-01
Before you can enter a new configuration and assign parameters to the CPU
of your S7-300, you must have created a project and selected the object that
you want to configure (here, your SIMATIC 300 station).
To make sure that there are no ‘old’ blocks in your CPU, you should perform
a memory reset before downloading the new configuration to the CPU.
We aim to show you the basic procedure for configuring and assigning
parameters using the TLIGHT sample program. The figure below gives you
an overview of this procedure:
Procedure for configuring and assigning parameters
Configure and assign parameters to the CPU
Reset CPU memory
Save configuration table
Download the configuration to your S7-300
Figure 5-1 Procedure for Configuring and Assigning Parameters
Since you have already created
the TLIGHT project, you can start
right away with the memory
reset of your S7-300!
Prerequisites
Basic Procedure
Configuring and Assigning Parameters to Your S7-300
How to Configure and Assign Parameters
To Next Page
Loading...
Need help?
General
