05.00 Logbook
Siemens AG 6SE7087-6AK85-1AA0
12-1
Rectifier/Regenerating Unit Operating Instructions
12 Logbook
The logbook must be kept up-to-date by the operating personnel.
All service and maintenance work carried out on the rectifier/regenerating unit should be entered briefly in
keywords into the logbook.
Continuous entries are important for maintenance and could be significant when it comes to warranty claims.
Similarly, in the event of software upgrading, it is important that a record of the parameter settings is available,
because during this procedure all values are reset to their original factory settings.
Location: ........................................................ Unit Order No.: ...................................................
Serial No.: ...................................................
Date Name Department Signature
Start-up settings
Start-up settings
change
Par-
No.
Parameter
designation
Factory setting Start-up setting Start-up setting
change
P050 Language 0
P051 Access Level 2
P052 Function select 0
P053 Parameter Access 6
P054 Display Light 0
P070 MLFB(6SE70 ... ) 0
P071 Line Volts dependent on P070
P074 Limit LowVoltage 61
P075 Rtd Amps dependent on P070
P076 Config. PCircuit 002
P077 Factory set.type 0
P090 Board Position 2 0
P091 Board Position 3 0
P140 Rectifier Resist i001=0.000
i002=0.000
i003=0.000
i004=0.000
i001=
i002=
i003=
i004=
i001=
i002=
i003=
i004=
P141 Rectifier Induct i001=0.00
i002=0.00
i003=0.00
i004=0.00
i001=
i002=
i003=
i004=
i001=
i002=
i003=
i004=
P142 Inverter Resist. i001=0.000
i002=0.000
i003=0.000
i004=0.000
i001=
i002=
i003=
i004=
i001=
i002=
i003=
i004=
AoteWell Automation Sales Team
Buy Siemens PLC HMI Drives at AoteWell.com
To Next Page
Loading...
Need help?
General