09.02 Technical Data
Siemens AG 6SE7087 6AK85-1AA0
14-11
Rectifier/Regenerating Unit Operating Instructions
14.3 Applied standards
DIN VDE 0100 Erection of power installations with rated voltages up to 1000 V,
Part 540 A11.91 Selection and erection of electrical equipment, earthing, PE conductor,
equipotential bonding conductor
DIN VDE 0106 Protection against electric shock:
Part 1 A05.82 Classification of electrical and electronic equipment (IEC 536)
Part 100 A03.83 Arrangement of actuation elements in the proximity of shock-hazard parts
DIN VDE 0110 Part 1 and 2
A01.89
Isolation coordination for electrical equipment in low-voltage installations
DIN VDE 0113 Safety of machines: electrical equipment of machines,
Part 1 A06.93 General requirements (EN 60204-1:1992)
DIN VDE 0160 E04.91 Equipping power installations with electronic equipment
DIN VDE 0298 Use of cables and insulated cables for power installations:
Part 2 A11.79 Recommended values for the current carrying capacity of cables with rated
voltages U
0
/ U to 18/30 kV
Part 4 A02.80 Recommended values for the current carrying capacity of cables
DIN VDE 0470 Part 1 A12.92 Types of protection, shock, foreign body and water protection for electrical
equipment (EN 60529: 1991)
DIN VDE 0558 Part1 A07.87 Semiconductor converters: general regulations and special regulations for
line-commutated converters
DIN VDE 0843 Electromagnetic compatibility of instrumentation and control equipment in
industrial process engineering:
Part 2 A09.87 Z Interference resistance to static electricity discharges; requirements and
measurement methods (IEC801-2) Ersetzt durch DIN EN 60801, Teil 2
(09.87)
DIN VDE 0875 RFI suppression of electrical equipment and installations:
Part 11 A12.88
Z
(EN 55014: 1987) Ersetzt durch DIN VDE 0875, Teil 14 und DIN VDE 0075
Part 1 A07.92 (EN 55011: 1991)
DIN 41494 Part 5 A9.80 Equipment practice for electronic facilities; subracks and modules
DIN 41651 Part 1 A9.89 Connectors for printed circuits for connecting ribbon cables with round
conductors; indirect insertion, grid dimension 2.54 mm
DIN IEC 60068 Part 2 Elektrotechnik; Grundlegende Umweltprüfverfahren; Prüfungen
DIN IEC 60721 Electrical engineering; classification of environmental conditions:
Part 3 A08.87 classes of influencing quantities
IEC 60801 Electromagnetic compatibility for industrial - process measurement and
control equipment
Part 4 Electrical fast transient / burst requirements
EN 60146-1-1: 1993 Semiconductor converters;
General requirements and line-commutated converters:
Part 1-1 Definition of basic requirements (IEC146-1-1991)
AoteWell Automation Sales Team
Buy Siemens PLC HMI Drives at AoteWell.com
To Next Page
Loading...
Need help?
General